SPS IPC Drives 2021
We are pleased to inform you that Sangalli Servomotori will be present at the SPS IPC DRIVES fair that will be held in Nuremberg from 23 to 25 November 2021.
We are waiting for you at the fair in Hall 4 - Stand 159
We are pleased to inform you that Sangalli Servomotori will be present at the SPS IPC DRIVES fair that will be held in Nuremberg from 23 to 25 November 2021.
We are waiting for you at the fair in Hall 4 - Stand 159
A range of LOW VOLTAGE brushless servomotors from the DSM5 series suitable for being powered by 24, 48 or 72 VDC DC BUS drives. The motors can accept any feedback device. Termination is via connectors or shielded cables.
A Series of actuators that integrate a hollow shaft brushless servomotor, a hollow shaft zero backlash gearbox and a multi-turn absolute feedback device.
The compact dimensions and adaptability to any drive make these products easily integrated into applications where zero backlash is required
A new, small, Size ZERO unit is available with ends of 40x40mm.
It is distinguished by: extreme compactness, excellent performance, very low cogging and flexibility.
It has the new M15 Ytec ®, even single, connector and can be supplied with various feed-backs. This solution, with epicyclic reduction gear, makes the motor the most extremely contained in terms of weight and dimensions.
Since April 2017, the insulating system of our motors, already conformed to UL standards of the United States, is extended also to the Canadian CSA standards.
Exploiting permanent magnet motor technology, and
integrating it into the unified MEC structure, we have created a new
line of high-performance motors, superior to the standards required by
legislation for the IE4 premium class!
Coupling to a sensor-less inverter allows for an economic solution with the lowest possible consumption.
The saving of energy
will be one of the driving forces in the next few years, and our IE5
Efficiency series is a tested solution ready for market demand.
A series of brushless Stator – Rotor sets from 37mm to 560mm with torques from 0.1 to 1.000 Nm. Ideal for integration into robots, compact machines and generators.
Made in AREA97
